Gear Lever finished !!! (and FMC PCB files added to Download Section)

Hello All,

because of the Installation of the Yoke System and the Pedals under the floor i was forced to take apart the complete Simulator. So i used the Chance to make a new MIP structure out of MDF material which is more stable that the original pressed Wood Chip structure. Of course when you do a new MIP holder you use the Chance to implement a lot of improvements. (New Monitor Holders, New wiring and )

YES – a new DIY Gear Lever with full functionality. You can find all detailed informations on the Page dedicated to the Gear Lever. Have a look here -> Gear Lever Page

LeverFinal

Leave a Reply

Your email address will not be published. Required fields are marked *